When 4 cycles are completed without the lid switch opening the inverter control assumes that the lid switch is defective.
Ge top load washer lid lock flashing.
I do not lid lock light flashing blinking on top load washing machine how to clear read more.
If the wire harness is okay replace the lid switch.
You cannot set the washer to lock for the entire cycle.
To reset washing machines that use the ge hydrowave system start by unplugging the washer for one minute.
Placing a separate magnet there will create a stable electromagnetic connection with the solenoid and trick the machine into thinking that the lid is.
Unplug the washer and repair or replace the lid switch wire harness.
Starting in 2015 top load washers feature a lid lock that engages when the washer is either load sensing before and during fill or when it is spinning above 50 rpm.
This switch is connected to a solenoid that completes a circuit allowing the machine to run only if the top is down.
However some washing machines come with a lid lock.
Most washing machines come equipped with a lid switch.
The inverter control expects to see the lid switch open after every cycle.
The lid lock light is flashing on my top load washer.
Plug the washing machine back in and then within 30 seconds quickly open and close the lid six times.
Soft close lid 8 spin speed option 6 wi fi enabled 4 efficiency.
High efficiency diamond gray top load washing machine with smart dispense and sanitize with oxi energy star 944 00.
I have an older kenmore top loading washing machine.
Press start button again to restart the cycle.
Top load washers consumer help indicator.
Sensing sensing load size and type before and during fill normal.
Get free shipping on qualified ge top load washers or buy online pick up in store today in the appliances department.
You ll need to do this within a 12 second period.
If f8 e1 or lf too long to fill appears in the display the washer is taking too long to fill or the washer is filling and draining.
Top load washer lid lock feature.
Set a magnet on the site where the lid lock switch meets the washer cabinet.
Pause cycle paused because the start pause button was pressed and the washer was set to pause.
Lid cycle stopped because lid is open.
It s possible the drain hose extends more than 4 5 114 mm into the standpipe.
I did some google searching and found that there could be a few different issues that are causing the lid lock light to flash or blink on the control panel of my washer.
This switch performs the same function but the lid must be locked in place for the machine to wash.
